Antique Radio Speaker/Grille Cloth, New Leaf Rev., 18" X 24", See Description

• Popularity - 13767 views, 1966.7 views per day, 7 days on eBay. Super high amount of views. 166 sold.
• Price - Avg: $0.00, Low: $0.00, High: $0.00. Best quality when compared to PicClick similar items.
• Seller - + items sold. 0% negative feedback. Great seller with very good positive feedback and over 50 ratings.

Note to International  Buyers<br>We are not selling internationally on eBay anymore, as eBay now requires us to pay all cost , including shipping , on a lost package, which is not guaranteed by USPS.<br>There are other ways to purchase from us, though sadly , due to another eBay rule, I cannot lead you there, however it is not hard to find us.<br>After offering our product for twelve years internationally,  I apologize to you all and I hope to hear from you again.<br>Thank you for all your support<br>New Leaf (reversible)<br>This<br>listing<br>is for one   18" x 24"<br>piece<br>Larger Sizes available,<br>Please contact us for any size<br>I have added some photos of the reverse side of cloth, installed in a restored Atwater Kent Model 635 to show the blend with natural wood tones under different lighting.<br>Another beautiful pattern , which originated under the Zenith brand.<br>Please be sure to click on<br>See other items<br>,<br>just below our ebay name in the top right corner of the listing.<br>Thank you,<br>Richmond Designs Inc<br>A  True 1930s Pattern Design<br>Thank you all,... for your support !!<br>Grill Cloth Installation Instructions<br>First,...mist the cloth lightly with a water mist, spraying lightly , not heavy.  Then set your clean  iron on low to medium heat. In doing so for speaker cloth,..<br>never hotter than you can touch without burning your hand.   Smooth the cloth if necessary,.. but do not  iron it completely dry.<br>You want the cloth to be damp during the application process. This allows the cloth to shrink as it dries stretching any wrinkles that may be left..<br>Next make sure your pattern is aligned straight with the edge of your board  across the top and down the side before applying the spray adhesive.<br>Then,  using 3M Super 27 or 77 spray adhesive, apply it to the edge of the board and  all around the outer edge about a one inch wide band  on the face side.<br>You do not want to spray glue all over the board.   Leave the inner field area of the board clean, free of any adhesive.<br>This leaves the cloth free to stretch as it dries.     (You can also spray the glue on a piece of paper and use a brush for applying in tight places.)<br>Let the glue dry for about 15 minutes. Do not spray adhesive anywhere on the cloth.<br>On a clean area of your work space, roll the cloth from the bottom up to the top, rolling your face side inward.<br>Start the application in one corner at the top checking your design to be straight across.  Then  roll it out top to bottom.  Make sure your first edge at the top is straight and secure. Then as you stretch the cloth gently, watch your pattern design , keeping it straight , so not to over stretch the design.   Tightening  slightly , top to bottom,... then side to side.  Once you have achieved the desired  position, fold the outer excess cloth down over the glued edge of your board.<br>Let the project sit about one hour, then after the cloth  has completely dried  you may finish the trimming the back edge.  Make sure to leave enough of the back edge of cloth to work with, in the event you may have to stretch an area a bit more.<br>Thank you ,<br>Richmond Designs Inc<br>Our  1930s duplications are sold all over the world.<br>Thank you for viewing,<br>Richmond Designs Inc<br>